MY-M215C 3D dental printer for dental clinic

Tray size: approximately 39cm long * 24cm wide

Powerful plaster oscillator (Xiao Fangzhen) Power supply voltage 220v/50hz±10% Power supply: 120w Maximum load: ≤2kg Dimensions: 20.5*15.5*10cm The weight of the whole machine is about 4KG

Item： Dental phantom head N.W.： 4.5KG G.W.： 5.5KG Packing dimension： 41*27*25cm Main material： aluminum&stainless steel Typodont： 28pcs or 32pcs Clamp availabl

1. Purpose: This machine is an indispensable equipment for dental restoration professions, and is mainly used to remove various tiny surface oxides. At the same time, it is also possible to cast glass beads on the surface of the plastic base. one year warranty 2. Technical parameters: Voltage: 110V / 220V Power rate: 50W (LED tube) Pressure: ≥4kg Sand size: 100#~120# Weight: 15kg 3. How to use: 1. First, insert each pipe joint tightly. 2. Insert the power cord and foot switch tube into the corresponding jacks. 3. Unscrew the lids of the two sand cups and pour in the sand. The height of the jar should be one-half of the height of the jar. The sand outlet pipe must not be buried, otherwise it will affect the sandblasting effect and block the gas path. 4. Adjust the pressure regulating valve so that the machine can only work when the pressure is greater than 0.4MPa. Adjust the commutation to control the left and right pens to produce sand. 5. When cleaning the sand in the machine, unscrew the screw directly below, lift the machine up, and the sand will flow out naturally from the screw hole. Four, faults and troubleshooting 1. If the foot switch leaks after turning on the air pump, it means that the foot switch is connected reversely, just exchange. 3. Poor sand production. Please check whether the pressure is above 4kg, adjust the pressure regulating valve first, and then check that too much or too little sand is poured in the sand tank. When the pressure gauge shows pressure, but the pen does not produce sand and there is no air leakage, it is blocked at this time, please unscrew the lock nut on the front of the pen barrel to clean it, and then step on the foot switch to give air, and finally screw on the lock nut. Five, matters needing attention 1. Be sure to pay attention to the cleaning of dust at all times during the use of the equipment, otherwise it will cause poor contact with the electrical parts and affect normal use. 2. The amount of sand